Pokazane rezultaty 1 do 1 z 1

Temat: silnik 1.8T AGU Wartości mierzone w blokach pomiarowych

  1. #1
    Coolfon's Avatar
    Data dołączenia
    Oct 2006
    Płeć
    mężczyzna
    Miasto
    Wolbrom/Kraków/Katowice
    Auto
    Audi A3 ABT
    Model
    A3 8L 3d
    Silnik
    1.8T AGU
    Pomógł
    12 razy
    Podziękował
    8 razy

    Domyślny silnik 1.8T AGU Wartości mierzone w blokach pomiarowych

    ; VAG-COM Measuring Block AGU Engine Label file.
    ; Component number 06A 906 018 CG
    ;
    ; Does not work with 06A 906 018 FA (2000 US 2.0L)
    ;

    1,0,Basic Functions - Spec figures at Idle
    001,1,Idle speed,800-920 rpm
    001,2,Engine load,0.5-1.5 m/s
    001,3,Throttle ang,0-5 deg.
    001,4,Ignition ang,6-12 BTDC
    ;
    2,0,Basic Functions - Spec figures at Idle
    002,1,Idle speed,800-920 rpm
    002,2,Engine load,0.5-1.5 m/s
    002,3,Inj. period,1.00-3.00 m/s
    002,4,Air mass in,1.8-4 g/s
    ;

    3,0,Basic Functions - - Spec figures at Idle
    003,1,Idle speed,800-920 rpm
    003,2,Supply volts,10-14.5V
    003,3,Coolant temp,80-105 d/C
    003,4,Intake temp,-45-108.5 d/C
    ;
    4,0,Idle Stabilisation - Spec figures at Idle
    004,1,Throttle ang.,0-5 deg.
    004,2,Idle mass,-1.7-1.7 A/T
    004,3,Idle mass,0 if man/t
    004,4,Op. mode,
    ;
    5,0,Idle Stabilisation - Spec figures at Idle
    005,1,Idle speed,800-920 rpm
    005,2,Spec. idle,860 rpm
    005,3,Idle reg,-10-10%
    005,4,Air mass in,1.8-4 g/s
    ;

    6,0,Idle Stabilisation - Spec figures at Idle
    006,1,Idle speed,800-920 rpm
    006,2,Idle reg,-10-10%
    006,3,Lambda reg,-10-10%
    006,4,Ign angle,6-12 BTDC
    ;
    7,0,Lambda learned values
    007,1,Lambda reg,-10-10%
    007,2,Probe volts,0-1V
    007,3,Valve duty,angle 0-99%
    007,4,Correction,0.3-1.25
    ;
    8,0,Lambda learned values
    008,1,Inj. period,1-3 m/s
    008,2,Idle learned,-10-10%
    008,3,Learned,-8-8%
    008,4,Vent mode
    ;

    9,0,Lambda learned values
    009,1,Idle speed,800-920 rpm
    009,2,Lambda reg,-10-10%
    009,3,Probe volts,0-1V
    009,4,Idle learned,-10-10%
    ;
    10,0,Fuel tank breather
    010,1,Valve duty,angle 0-99%
    010,2,Correction,0.3-1.25
    010,3,Filter state,-3-32
    010,4,Purge rate,0-0.3
    ;
    11,0,Fuel Consumption
    011,1,Idle speed,800-920 rpm
    011,2,Engine load,0.5-1.5 m/s
    011,3,Road speed,km/h
    011,4,Consumption,l/h
    ;

    12,0,Fuel Consumption [Not verified in manual]
    012,1,Engine rpm,0-6800 rpm
    012,2,Voltage,V
    012,3,Consumption,l/h
    012,4,Ign degrees,deg
    ;
    13,0,Knock regulation [Not verified in manual]
    ;
    14,0,Knock control
    014,1,Engine speed,0-6800 rpm
    014,2,Engine load,0-10 m/s
    014,3,Cyl 1 retard,0-9 degCA
    014,4,Cyl 2 retard,0-9 degCA
    ;

    15,0,Knock control
    015,1,Engine speed,0-6800 rpm
    015,2,Engine load,0-10 m/s
    015,3,Cyl 3 retard,0-9 degCA
    015,4,Cyl 4 retard,0-9 degCA
    ;
    16,0,Knock control
    016,1,Sens 1 volts,0.4-1.4V
    016,2,Sens 2 volts,0.4-1.4V
    016,3,Sens 3 volts,0.4-1.4V
    016,4,Sens 4 volts,0.4-1.4V
    ;
    17,0,[Not listed in manual - Using default labels]
    ;

    18,0,Altitude adaptation
    018,1,Idle speed,800-920 rpm
    018,2,Engine load,0.5-1.5 m/s
    018,3,Throttle,valve angle
    018,4,Alt. correc.,-50-10%
    ;
    19,0,Additional signals
    019,1,Engine speed,0-6800 rpm
    019,2,Engine load,0-10 m/s
    019,3,Additional,signals
    019,4,Ign. timing,20Atdc-42Btdc
    ;
    20,0,Operating Modes
    020,1,Idle speed,800-920 rpm
    020,2,Auto trans,Neutral/ON
    020,3,Air cond.,AC High/Low
    020,4,A/C Comp.,Compr ON/OFF
    ;

    21,0,Lambda Control
    021,1,Idle speed,800-920 rpm
    021,2,Engine load,0.5-1.5 m/s
    021,3,Coolant temp,-40-125 deg/C
    021,4,Lambda mode,
    ;
    23,0,Throttle valve adaptation
    023,1,Learning req.,100000
    023,2,Min stop,72-95%
    023,3,Emerg. stop,60-91%
    023,4,Max stop,18-54%
    ;

    24,0,Knock control
    024,1,Engine speed,0-6800 rpm
    024,2,Engine load,0-10 m/s
    024,3,Ign timing,20Atdc-42Btdc
    024,4,Sum of ret.,angle 0-36
    ;
    25,0,Charge Pressure control
    025,1,Spec. load,3-8 m/s
    025,2,Load correc.,0-8 m/s
    025,3,Actual load,0.5-8 m/s
    025,4,Valve cycle,0-99%
    ;
    26,0,[Not listed in manual - Using default labels]
    ;

    27,0,[Not listed in manual - Using default labels]
    ;
    66,0,Cruise control
    066,1,Road speed,km/h
    066,2,Switch pos.,xxxx
    066,3,Spec. speed
    066,4,CCS switch,position
    ;
    95,0,Basic functions
    095,1,Idle speed,800-920 rpm
    095,2,Engine load,0.5-1.5 m/s
    095,3,Ign timing,
    095,4,Coolant temp.,80-105 degC
    ;
    97,0,[Not listed in manual - Using default labels]
    ;
    98,0,Throttle Valve Matching/Calibration/Adaptation
    098,1,Valve voltage,0-5V
    098,2,Sender voltage,0-5V
    098,3,Opr. mode,
    098,4,Adapt mode,RUN/OK/ERROR
    ;
    99,0,Lambda regulation
    099,1,Engine speed,0-6800 rpm
    099,2,Coolant temp,-40-125 deg/C
    099,3,Lambda reg.,-10-10%
    099,4,Lambda mode
    ;
    ;End of File








    zamieszczam link do instrukcji w PDF-ie gdyby fotki wygasły
    http://hostuje.net/file.php?id=fa9a4...45cccccda9d6a7
    Ostatnio edytowany przez klamamoto - 01-08-15 o 17:04
    Srebrny pocisk ...



Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Zasady postowania

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •